Reparatur der elektronischen Servolenkung: Moderne Lenkung

Diagnostic Tools and Procedures

Essential Tools for EPS System Diagnostics

When dealing with electronic power steering (EPS) malfunctions, mechanics rely on specialized diagnostic equipment. Modern garages typically use advanced scanners that interface directly with the vehicle's EPS control unit. These devices reveal critical operational data - from torque sensor outputs to motor current draw - helping technicians trace electrical gremlins to their source. Without proper diagnostic tools, even experienced mechanics would be working blind when tackling EPS issues.

Initial Physical Inspection

Before connecting any diagnostic equipment, technicians always begin with a meticulous visual examination. They look for obvious red flags: corroded connectors in the steering column, compromised wiring insulation near moving parts, or hydraulic fluid pooling under the rack assembly. The steering shaft universal joints demand particular attention, as their wear often manifests as play in the steering wheel before triggering fault codes.

Electrical System Verification

Since EPS systems live and die by their electrical supply, technicians methodically check the entire power delivery chain. They verify battery voltage with the engine off (should be 12.6V minimum), test alternator output under load (13.8-14.4V), and inspect ground connections at the chassis and control module. A single poor ground connection can cause erratic EPS behavior that mimics more serious component failures.

Sensor Validation Process

Modern EPS systems employ multiple sensors that require careful testing:

• Torque sensors: Check for smooth resistance changes during steering wheel rotation
• Position sensors: Verify output correlates with wheel angle
• Vehicle speed sensors: Confirm signal integrity matches speedometer readings

Control Module Evaluation

The EPS computer undergoes rigorous testing beyond simple code reading. Technicians monitor CAN bus communication, check for firmware updates, and verify proper sleep/wake cycles. Some shops use thermal imaging to spot overheating components that might cause intermittent failures. Many failed modules actually suffer from external issues like voltage spikes or software conflicts.

Mechanical Component Inspection

Even in electric systems, mechanical wear remains a concern. Technicians check for:

• Rack bushings wear (excess movement)
• Pinion gear backlash (should be under 0.5mm)
• Intermediate shaft couplers (common failure point)

Hydraulic System Maintenance

While many EPS systems are fully electric, hybrid electro-hydraulic systems require fluid checks. Technicians:

• Inspect fluid color (should be clear, not dark)
• Check for metal particles (indicate pump wear)
• Verify pressure at various RPMs

Advanced EPS System Troubleshooting and Maintenance

EPS System Architecture Fundamentals

Effective troubleshooting begins with understanding the three core EPS architectures:

1. Column-drive (common in smaller vehicles)
2. Pinion-drive (offers better feel)
3. Rack-drive (highest torque capacity)

Failure Pattern Recognition

Seasoned technicians recognize these common EPS failure sequences:

• Cold weather stiff steering (usually battery related)
• Intermittent power loss (often ignition switch issues)
• Steering wheel vibration (typically torque sensor calibration)

Advanced Diagnostic Methodology

Beyond basic code scanning, experts employ:

• Current waveform analysis (detects motor brush wear)
• Vibration spectrum analysis (identifies mechanical issues)
• Thermal cycling tests (finds heat-related failures)

Component-Specific Testing Protocols

Each EPS component requires unique testing approaches:

System Validation Procedures

After repairs, comprehensive validation includes:

1. Static tests (ignition on, engine off)
2. Low-speed maneuvers in parking lot
3. Highway-speed stability checks